Free CCNA 200-301 Dumps 2026

  1. Home
  2. /
  3. Free Dumps
  4. /
  5. Free CCNA 200-301 Dumps...

❌ Tired of Failing with Outdated CCNA Dumps?

Cisco dumps don’t work anymore. Questions change constantly. Stop wasting time and failing exams. We guarantee your CCNA 200-301 success.

24/7 WhatsApp Support
100% pass rate since 2015
Pay after you pass – $0 upfront
Free retake or we take exam for you
Full refund protection
Proxy Exam Service

We do not sell unreliable dumps or brain dumps. We offer a real Live Exam Proxy service – you pay only after you officially pass. If you keep failing with outdated CCNA dumps, if the exam questions are different, if you need a guaranteed way to pass – we take your exam for you. No upfront fees. No hidden tricks.



Chat with Us on WhatsApp

 

Question 1381
0
Please leave a feedback on thisx

Cisco_CCNA-200-301_1381_Certget

Refer to the exhibit. Which next-hop IP address has the least desirable metric when sourced from R1?

  • A. 10.10.10.4
  • B. 10.10.10.5
  • C. 10.10.10.3
  • D. 10.10.10.2

 

 

Question 1382
0
Please leave a feedback on thisx

Cisco_CCNA-200-301_1382_Certget

Refer to the exhibit. Router R14 is in the process of being configured. Which configuration must be used to establish a host route to a PC 10?

  • A. ip route 10.80.65.10 255.255.255.254 10.80.65.1
  • B. ip route 10.80.65.10 255.255.255.255 10.73.65.66
  • C. ip route 10.73.65.66 0.0.0.255 10.80.65.10
  • D. ip route 10.73.65.66 255.0.0.0 10.80.65.10

 

 

Question 1383
0
Please leave a feedback on thisx

Cisco_CCNA-200-301_1383_Certget

Refer to the exhibit. What does route 10.0.1.3/32 represent in the routing table?

  • A. all hosts in the 10.0.1.0 subnet
  • B. a single destination address
  • C. the source 10.0.1.100
  • D. the 10.0.0.0 network

 

 

Question 1384
0
Please leave a feedback on thisx

Cisco_CCNA-200-301_1384_Certget

Refer to the exhibit. A network engineer started to configure two directly-connected routers as shown. Which command sequence must the engineer configure on R2 so that the two routers become OSPF neighbors?

  • A. interface GigabitEthernet0/1
    ip ospf 1 area 1
  • B. router ospf 1
    network 192.168.12.1 0.0.0.0 area 1
  • C. interface GigabitEthernet0/1
    ip ospf 1 area 0
  • D. router ospf 1
    network 192.168.12.0 0.0.0.127 area 0

Question 1385
0
Please leave a feedback on thisx

A network engineer is upgrading a small data center to host several new applications, including server backups that are expected to account for up to 90% of the bandwidth during peak times. The data center connects to the MPLS network provider via a primary circuit and a secondary circuit. How does the engineer inexpensively update the data center to avoid saturation of the primary circuit by traffic associated with the backups?

  • A. Assign traffic from the backup servers to a dedicated switch.
  • B. Place the backup servers in a dedicated VLAN.
  • C. Advertise a more specific route for the backup traffic via the secondary circuit.
  • D. Configure a dedicated circuit for the backup traffic.

Question 1386
0
Please leave a feedback on thisx

Which interface is used for out-of-band management on a WLC?

  • A. management
  • B. virtual
  • C. dynamic
  • D. service port

Question 1387
0
Please leave a feedback on thisx

A wireless access point is needed and must meet these requirements:
• “zero-touch” deployed and managed by a WLC
• process only real-time MAC functionality
• used in a split-MAC architecture

Which access point type must be used?

  • A. mesh
  • B. autonomous
  • C. lightweight
  • D. cloud-based

Question 1388
0
Please leave a feedback on thisx

What is a reason to implement LAG on a Cisco WLC?

  • A. Allow for stateful failover between WLCs.
  • B. Increase security by encrypting management frames.
  • C. Increase the available throughput on the link.
  • D. Enable the connected switch ports to use different Layer 2 configurations.

 

 

Question 1389
0
Please leave a feedback on thisx

Which step immediately follows receipt of the EAP success message when session resumption is disabled for an EAP-TLS connection?

  • A. PMKID caching
  • B. four-way handshake
  • C. 802.1X authentication
  • D. EAPOL-key frame

 

 

Question 1390
0
Please leave a feedback on thisx

Which port type does a lightweight AP use to connect to the wired network when it is configured in local mode?

  • A. EtherChannel
  • B. access
  • C. LAG
  • D. trunk

 

 

 

 

❌ Tired of Failing with Outdated CCNA Dumps?

Cisco dumps don’t work anymore. Questions change constantly. Stop wasting time and failing exams. We guarantee your CCNA 200-301 success.

24/7 WhatsApp Support
100% pass rate since 2015
Pay after you pass – $0 upfront
Free retake or we take exam for you
Full refund protection
Proxy Exam Service

We do not sell unreliable dumps or brain dumps. We offer a real Live Exam Proxy service – you pay only after you officially pass. If you keep failing with outdated CCNA dumps, if the exam questions are different, if you need a guaranteed way to pass – we take your exam for you. No upfront fees. No hidden tricks.



Chat with Us on WhatsApp

error: Content is protected !!