❌ Tired of Failing with Outdated CCNA Dumps?
Cisco dumps don’t work anymore. Questions change constantly. Stop wasting time and failing exams. We guarantee your CCNA 200-301 success.
100% pass rate since 2015
Pay after you pass – $0 upfront
Free retake or we take exam for you
Full refund protection
Proxy Exam Service
We do not sell unreliable dumps or brain dumps. We offer a real Live Exam Proxy service – you pay only after you officially pass. If you keep failing with outdated CCNA dumps, if the exam questions are different, if you need a guaranteed way to pass – we take your exam for you. No upfront fees. No hidden tricks.
An engineer is configuring data and voice services to pass through the same port. The designated switch interface fastethernet0/1 must transmit packets using the same priority for data when they are received from the access port of the IP phone. Which configuration must be used?
- A. interface fastethernet0/1 switchport voice vlan dot1p
- B. interface fastethernet0/1 switchport priority extend cos 7
- C. interface fastethernet0/1 switchport voice vlan untagged
- D. interface fastethernet0/1 switchport priority extend trust
Refer to the exhibit. Which change to the configuration on Switch2 allows the two switches to establish an EtherChannel?
- A. Change the LACP mode to desirable
- B. Change the protocol to PAgP and use auto mode
- C. Change the LACP mode to active
- D. Change the protocol to EtherChannel mode on
Refer to the exhibit. An engineer must configure the interface that connects to PC1 and secure it in a way that only PC1 is allowed to use the port. No VLAN tagging can be used except for a voice VLAN. Which command sequence must be entered to configure the switch?
- A. SW1(config-if)#switchport mode dynamic auto SW1(config-if)#switchport port-security SW1(config-if)#switchport port-security violation restrict
- B. SW1(config-if)#switchport mode nonegotiate SW1(config-if)#switchport port-security SW1(config-if)#switchport port-security maximum 1
- C. SW1(config-if)#switchport mode access SW1(config-if)#switchport port-security SW1(config-if)#switchport port-security mac-address 0050.7966.6800
- D. SW1(config-if)#switchport mode dynamic desirable SW1(config-if)#switchport port-security mac-address 0050.7966.6800 SW1(config-if)#switchport port-security mac-address sticky
Which protocol must be implemented to support separate authorization and authentication solutions for wireless APs?
- A. RADIUS
- B. TACACS+
- C. 802.1X
- D. Kerberos
Which port type supports the spanning-tree portfast command without additional configuration?
- A. trunk ports
- B. Layer 3 sub interfaces
- C. Layer 3 main interfaces
- D. access ports
Refer to the exhibit. What are two conclusions about this configuration? (Choose two.)
- A. The spanning-tree mode is Rapid PVST+
- B. This tea root bridge
- C. The spanning-tree mode is PVST+
- D. The designated port is FastEthernet 2/1
- E. The root port is FastEthernet 2/1
A Cisco engineer must configure a single switch interface to meet these requirements:
✑ Accept untagged frames and place them in VLAN 20
Accept tagged frames in VLAN 30 when CDP detects a Cisco IP phone
Which command set must the engineer apply?
- A. switchport mode dynamic desirable switchport access vlan 20 switchport trunk allowed vlan 30 switchport voice vlan 30
- B. switchport mode access switchport access vlan 20 switchport voice vlan 30
- C. switchport mode dynamic auto switchport trunk native vlan 20 switchport trunk allowed vlan 30 switchport voice vlan 30
- D. switchport mode trunk switchport access vlan 20 switchport voice vlan 30
What does a switch use to build its MAC address table?
- A. VTP
- B. DTP
- C. ingress traffic
- D. egress traffic
Refer to the exhibit. The EtherChannel is configured with a speed of 1000 and duplex as full on both ends of channel group 1. What is the next step to configure the channel on switch A to respond to but not initiate LACP communication?
- A. interface range gigabitethernet0/0/0-15 channel-group 1 mode on
- B. interface range gigabitethernet0/0/0-15 channel-group 1 mode desirable
- C. interface port-channel 1 channel-group 1 mode auto
- D. interface port-channel 1 channel-group 1 mode passive
Which command entered on a switch configured with Rapid PVST+ listens and learns for a specific time period?
- A. switch(config)#spanning-tree vlan 1 priority 4096
- B. switch(config)#spanning-tree vlan 1 hello-time 10
- C. switch(config)#spanning-tree vlan 1 max-age 6
- D. switch(config)#spanning-tree vlan 1 forward-time 20
❌ Tired of Failing with Outdated CCNA Dumps?
Cisco dumps don’t work anymore. Questions change constantly. Stop wasting time and failing exams. We guarantee your CCNA 200-301 success.
100% pass rate since 2015
Pay after you pass – $0 upfront
Free retake or we take exam for you
Full refund protection
Proxy Exam Service
We do not sell unreliable dumps or brain dumps. We offer a real Live Exam Proxy service – you pay only after you officially pass. If you keep failing with outdated CCNA dumps, if the exam questions are different, if you need a guaranteed way to pass – we take your exam for you. No upfront fees. No hidden tricks.