Free CCNA 200-301 Dumps 2026

 

Refer to the exhibit. Which command provides this output?

 

A. show ip route
B. show ip interface
C. show interface
D. show cdp neighbor

 

 

Which set of action satisfy the requirement for multi-factor authentication?

A. The user swipes a key fob, then clicks through an email link
B. The user enters a user name and password, and then clicks a notification in an authentication app on a mobile device
C. The user enters a PIN into an RSA token, and then enters the displayed RSA key on a login screen
D. The user enters a user name and password and then re-enters the credentials on a second screen

 

 

Which mode allows access points to be managed by Cisco Wireless LAN Controllers?

A. autonomous
B. lightweight
C. bridge
D. mobility express

 

 

Router A learns the same route from two different neighbors, one of the neighbor routers is an OSPF neighbor and the other is an EIGRP neighbor.
What is the administrative distance of the route that will be installed in the routing table?

A. 20
B. 90
C. 110
D. 115

 

Refer to the exhibit. What is the effect of this configuration?

A. The switch port interface trust state becomes untrusted
B. The switch port remains administratively down until the interface is connected to another switch
C. Dynamic ARP inspection is disabled because the ARP ACL is missing
D. The switch port remains down until it is configured to trust or untrust incoming packets

 

 

Refer to the exhibit. Which prefix does Router1 use for traffic to Host A?

A. 10.10.10.0/28
B. 10.10.13.0/25
C. 10.10.13.144/28
D. 10.10.13.208/29

 

 

What are two characteristics of a controller-based network? (Choose two)

A. The administrator can make configuration updates from the CLI
B. It uses northbound and southbound APIs to communicate between architectural layers
C. It moves the control plane to a central point.
D. It decentralizes the control plane, which allows each device to make its own forwarding decisions
E. It uses Telnet to report system issues.

 

 

Refer to exhibit. Which statement explains the configuration error message that is received?

A. It is a broadcast IP address
B. The router does not support /28 mask.
C. It belongs to a private IP address range.
D. IT is a network IP address.

 

 

Drag and Drop Question
Drag and drop the application protocols from the left onto the transport protocols that is uses on the right.

 

 

 

 

Which command must you enter to guarantee that an HSRP router with higher priority becomes the HSRP primary router after it is reloaded?

A. standby 10 preempt
B. standby 10 version 1
C. standby 10 priority 150
D. standby 10 version 2