Free CCNA 200-301 Dumps 2026

  1. Home
  2. /
  3. Free Dumps
  4. /
  5. Free CCNA 200-301 Dumps...

❌ Tired of Failing with Outdated CCNA Dumps?

Cisco dumps don’t work anymore. Questions change constantly. Stop wasting time and failing exams. We guarantee your CCNA 200-301 success.

24/7 WhatsApp Support
100% pass rate since 2015
Pay after you pass – $0 upfront
Free retake or we take exam for you
Full refund protection
Proxy Exam Service

We do not sell unreliable dumps or brain dumps. We offer a real Live Exam Proxy service – you pay only after you officially pass. If you keep failing with outdated CCNA dumps, if the exam questions are different, if you need a guaranteed way to pass – we take your exam for you. No upfront fees. No hidden tricks.



Chat with Us on WhatsApp

 

Question 311
0
Please leave a feedback on thisx

Which WLC interface provides out-of-band management in the Cisco Unified Wireless Network Architecture?

  • A. AP-Manager
  • B. service port
  • C. dynamic
  • D. virtual

 

 

Question 312
0
Please leave a feedback on thisx

CCNA_Dumps_312_Certget

Refer to the exhibit. The network engineer is configuring a new WLAN and is told to use a setup password for authentication instead of the RADIUS servers.
Which additional set of tasks must the engineer perform to complete the configuration?

  • A. Disable PMF Enable PSK Enable 802.1x
  • B. Select WPA Policy Enable CCKM Enable PSK
  • C. Select WPA Policy Select WPA2 Policy Enable FT PSK
  • D. Select WPA2 Policy Disable PMF Enable PSK

 

 

Question 313
0
Please leave a feedback on thisx

Which mode must be set for Aps to communicate to a Wireless LAN Controller using the Control and Provisioning of Wireless Access Points (CAPWAP) protocol?

  • A. route
  • B. bridge
  • C. lightweight
  • D. autonomous

 

 

Question 314
0
Please leave a feedback on thisx

Which switch technology establishes a network connection immediately when it is plugged in?

  • A. PortFast
  • B. BPDU guard
  • C. UplinkFast
  • D. BackboneFast

 

 

Question 315
0
Please leave a feedback on thisx

Which command on a port enters the forwarding state immediately when a PC is connected to it?

  • A. switch(config)#spanning-tree portfast default
  • B. switch(config)#spanning-tree portfast bpduguard default
  • C. switch(config-if)#spanning-tree portfast trunk
  • D. switch(config-if)#no spanning-tree portfast

 

 

Question 316
0
Please leave a feedback on thisx

If a switch port receives a new frame while it is actively transmitting a previous frame, how does it process the frames?

  • A. The new frame is delivered first, the previous frame is dropped, and a retransmission request is sent
  • B. The previous frame is delivered, the new frame is dropped, and a retransmission request is sent
  • C. The new frame is placed in a queue for transmission after the previous frame
  • D. The two frames are processed and delivered at the same time

 

 

Question 317
0
Please leave a feedback on thisx

CCNA_Dumps_317_Certget

Refer to the exhibit. The entire MAC address table for SW1 is shown here:

CCNA_Dumps_317_w2_Certget

What does SW1 do when Br-4 sends a frame for Br-2

  • A. It performs a lookup in the MAC address table for Br-4 and discards toe frame due to a missing entry.
  • B. It floods the frame out or all ports except on the port where Br-2 is connected.
  • C. It Inserts the source MAC address and port into the forwarding table and forwards the frame to Br-2.
  • D. It maps the Layer 2 MAC address for Fa0/3 to the Layer 3 IP address and towards the frame.

 

 

 

Question 318
0
Please leave a feedback on thisx

How does MAC learning function?

  • A. adds unknown source MAC addresses to the CAM table
  • B. protects against denial of service attacks
  • C. populates the ARP table with the egress port
  • D. sends an ARP request to locate unknown destinations

 

 

Question 319
0
Please leave a feedback on thisx

CCNA_Dumps_319_w2_Certget

Refer to the exhibit. An engineer is configuring an EtherChannel using LACP between Switches 1 and 2.
Which configuration must be applied so that only Switch 1 sends LACP initiation packets?

A

CCNA_Dumps_319_2_w2_Certget

B

CCNA_Dumps_319_3_w2_Certget

C

CCNA_Dumps_319_4_w2_Certget

D

CCNA_Dumps_319_5_w2_Certget

Correct Answer: B

 

 

Question 320
0
Please leave a feedback on thisx

CCNA_Dumps_320_Certget

CCNA_Dumps_320_2_Certget

Refer to the exhibit. The entire Marketing-SW1 MAC address table is shown here:
What does the switch do when PC-4 sends a frame to PC-1?

 

A. It performs a lookup in the MAC address table and discards the frame due to a missing entry.
B. It maps the Layer 2 MAC address to the Layer 3 IP address and forwards the frame.
C. It inserts the source MAC address and port into the table and forwards the frame to PC-1. Most Voted
D. It floods the frame out of all ports except on the port where PC-1 is connected.

 

 

❌ Tired of Failing with Outdated CCNA Dumps?

Cisco dumps don’t work anymore. Questions change constantly. Stop wasting time and failing exams. We guarantee your CCNA 200-301 success.

24/7 WhatsApp Support
100% pass rate since 2015
Pay after you pass – $0 upfront
Free retake or we take exam for you
Full refund protection
Proxy Exam Service

We do not sell unreliable dumps or brain dumps. We offer a real Live Exam Proxy service – you pay only after you officially pass. If you keep failing with outdated CCNA dumps, if the exam questions are different, if you need a guaranteed way to pass – we take your exam for you. No upfront fees. No hidden tricks.



Chat with Us on WhatsApp

error: Content is protected !!