Free CCNA 200-301 Dumps 2026

 

What are two improvements provided by automation for network management in an SDN environment? (Choose two)

A. Data collection and analysis tools establish a baseline for the network
B. Artificial intelligence identifies and prevents potential design failures.
C. Machine learning minimizes the overall error rate when automating troubleshooting processes
D. New devices are onboarded with minimal effort
E. Proprietary Cisco APIs leverage multiple network management tools.

 

 

Refer to the exhibit. Shortly after SiteA was connected to SiteB over a new single-mode fiber path, users at SiteA report intermittent connectivity issues with applications hosted at SiteB. What is the cause of the intermittent connectivity issue?

A. Interface errors are incrementing
B. An incorrect SFP media type was used at SiteA
C. High usage is causing high latency
D. The sites were connected with the wrong cable type

 

Which technology allows for multiple operating systems to be run on a single host computer?

A. virtual routing and forwarding
B. network port ID v sualization
C. virtual device on exts
D. server visualization

 

 

How does authentication differ from authorization?

A. Authentication verifies the identity of a person accessing a network, and authorization determines what resource a user can access.
B. Authentication is used to record what resource a user accesses, and authorization is used to determine what resources a user can access
C. Authentication is used to determine what resources a user is allowed to access, and authorization is used to track what equipment is allowed access to the network
D. Authentication is used to verify a person’s identity, and authorization is used to create syslog messages for logins

 

 

What occurs when overlapping Wi-Fi channels are implemented?

A. The wireless network becomes vulnerable to unauthorized access.
B. Wireless devices are unable to distinguish between different SSIDs
C. Users experience poor wireless network performance.
D. Network communications are open to eavesdropping.

 

 

Refer to the exhibit. An administrator must turn off the Cisco Discovery Protocol on the port configured with address last usable address in the 10.0.0.0/30 subnet. Which command set meets the requirement?

A. interface gi0/1
no cdp enable

B. interface gi0/1
clear cdp table

C. interface gi0/0
no cdp advertise-v2

D. interface gi0/0
no cdp run

 

 

Refer to the exhibit. The entire contents or the MAC address table are shown. Sales-4 sends a data frame to Sales-1.

What does the switch do as it receives the frame from Sales-4?

A. Perform a lookup in the MAC address table and discard the frame due to a missing entry.
B. Insert the source MAC address and port into the forwarding table and forward the frame to Sales- 1.
C. Map the Layer 2 MAC address to the Layer 3 IP address and forward the frame.
D. Flood the fr me out of all ports except on the port where Sales-1 is connected.

 

 

Which 802.11 management frame type is sent when a client roams between access points on the same SSID?

A. Reassociation Request
B. Probe Request
C. Authentication Request
D. Association Request

 

 

Drag and Drop Question
Drag and drop the TCP/IP protocols from the left onto their primary transmission protocols on the right.

 

 

An engineer must configure the IPv6 address 2001:0db8:0000:0000:0700:0003:400F:572B on the serial0/0 interface of the HQ router and wants to compress it for easier configuration.
Which command must be issued on the router interface?

A. ipv6 address 2001:db8::700:3:400F:572B
B. ipv6 address 2001:db8:0::700:3:4F:572B
C. ipv6 address 2001:Odb8::7:3:4F:572B
D. ipv6 address 2001::db8:0000::700:3:400F:572B