Free CCNA 200-301 Dumps 2026

 

What does a router do when configured with the default DNS lookup settings, and a URL is entered on the CLI?

A. initiates a ping request to the URL
B. prompts the user to specify the desired IP address
C. continuously attempts to resolve the URL until the command is cancelled
D. sends a broadcast message in an attempt to resolve the URL

 

 

Refer to the exhibit. An administrator must configure interfaces Gi1/1 and Gi1/3 on switch SW11 PC-1 and PC- 2 must be placed in the Data VLAN and Phone-1 must be placed in the Voice VLAN.
Which configuration meets these requirements?

 

A. Option A
B. Option B
C. Option C
D. Option D

 

 

Which condition must be met before an NMS handles an SNMP trap from an agent?

A. The NMS software must be loaded with the MIB associated with the trap.
B. The NMS must be configured on the same router as the SNMP agent
C. The NMS must receive a trap and an inform message from the SNMP agent within a configured interval
D. The NMS must receive the same trap from two different SNMP agents to verify that it is reliable.

 

 

What is the effect when loopback interfaces and the configured router ID are absent during the OSPF Process configuration?
A. No router ID is set, and the OSPF protocol does not run.
B. The highest up/up physical interface IP address is selected as the router ID.
C. The lowest IP address is incremented by 1 and selected as the router ID.
D. The router ID 0.0.0.0 is selected and placed in the OSPF process.

 

 

Which device controls the forwarding of authentication requests for users when connecting to the network using a lightweight access point?

A. TACACS server
B. wireless access point
C. RADIUS server
D. wireless LAN controller

 

 

A network administrator must enable DHCP services between two sites. What must be configured for the router to pass DHCPDISCOVER messages on to the server?

A. a DHCP Relay Agent
B. DHCP Binding
C. a DHCP Pool
D. DHCP Snooping

 

 

A network administrator needs to aggregate 4 ports into a single logical link which must negotiate layer 2 connectivity to ports on another switch.
What must be configured when using active mode on both sides of the connection?

A. 802.1q trunks
B. Cisco vPC
C. LLDP
D. LACP

 

 

Refer to the exhibit. Which path is used by the router for internet traffic?

A. 209.165.200.0/27
B. 10.10.10.0/28
C. 0.0.0.0/0
D. 10.10.13.0/24

 

 

How does a Cisco Unified Wireless network respond to Wi-Fi channel overlap?

A. It alternates automatically between 2.4 GHz and 5 GHz on adjacent access points
B. It allows the administrator to assign channels on a per-device or per-interface basis.
C. It segregates devices from different manufacturers onto different channels.
D. It analyzes client load and background noise and dynamically assigns a channel.