❌ Tired of Failing with Outdated CCNA Dumps?
Cisco dumps don’t work anymore. Questions change constantly. Stop wasting time and failing exams. We guarantee your CCNA 200-301 success.
100% pass rate since 2015
Pay after you pass – $0 upfront
Free retake or we take exam for you
Full refund protection
Proxy Exam Service
We do not sell unreliable dumps or brain dumps. We offer a real Live Exam Proxy service – you pay only after you officially pass. If you keep failing with outdated CCNA dumps, if the exam questions are different, if you need a guaranteed way to pass – we take your exam for you. No upfront fees. No hidden tricks.
Drag and Drop Question
Refer to the exhibit. Drag and drop the networking parameters from the left on to the correct values on the right.
Which NAT term is defined as a group of addresses available for NAT use?
A. NAT pool
B. dynamic NAT
C. static NAT
D. one-way NAT
After you deploy a new WLAN controller on your network, which two additional tasks should you consider? (Choose two)
A. deploy load balancers
B. configure additional vlans
C. configure multiple VRRP groups
D. deploy POE switches
E. configure additional security policies
Which component of an Ethernet frame is used to notify a host that traffic is coming?
A. start of frame delimiter
B. Type field
C. preamble
D. Data field
Refer to the exhibit. How will switch SW2 handle traffic from VLAN 10 on SW1?
A. It sends the traffic to VLAN 10.
B. It sends the traffic to VLAN 100.
C. It drops the traffic.
D. It sends the traffic to VLAN 1.
You are configuring your edge routers interface with a public IP address for Internet connectivity.
The router needs to obtain the IP address from the service provider dynamically. Which command is needed on interface FastEthernet 0/0 to accomplish this?
A. ip default-gateway
B. ip route
C. ip default-network
D. ip address dhcp
E. ip address dynamic
What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two)
A. when the sending device waits 15 seconds before sending the frame again
B. when the cable length limits are exceeded
C. when one side of the connection is configured for half-duplex
D. when Carner Sense Multiple Access/Collision Detection is used
E. when a collision occurs after the 32nd byte of a frame has been transmitted
Which IPv6 address type provides communication between subnets and cannot route on the Internet?
A. global unicast
B. unique local
C. link-local
D. multicast
A user configured OSPF in a single area between two routers A serial interface connecting R1 and R2 is running encapsulation PPP.
By default which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?
A. port-to-multipoint
B. broadcast
C. point-to-point
D. non-broadcast
You have two paths for the 10.10.10.0 network – one that has a feasible distance of 3072 and the other of 6144.
What do you need to do to load balance your EIGRP routes?
A. Change the maximum paths to 2
B. Change the configuration so they both have the same feasible distance
C. Change the variance for the path that has a feasible distance of 3072 to 2
D. Change the IP addresses so both paths have the same source IP address
❌ Tired of Failing with Outdated CCNA Dumps?
Cisco dumps don’t work anymore. Questions change constantly. Stop wasting time and failing exams. We guarantee your CCNA 200-301 success.
100% pass rate since 2015
Pay after you pass – $0 upfront
Free retake or we take exam for you
Full refund protection
Proxy Exam Service
We do not sell unreliable dumps or brain dumps. We offer a real Live Exam Proxy service – you pay only after you officially pass. If you keep failing with outdated CCNA dumps, if the exam questions are different, if you need a guaranteed way to pass – we take your exam for you. No upfront fees. No hidden tricks.